STRADDLE TOLERANCE AND SURFACE MILLING TO CLOSE TOLERANCES

Series: Milling machine series

Duration: 27 min

Year Published: 1942

Creator: Castle Films

Format: 16mm

Sound: Sound

Description: Produced by US Office of education. Shows the set-up and operation of cutters used when surface milling a solid block of steel on four sides and then straddle milling the block into T-section, working to close tolerances. The piece is clamped to the table on finger clamps in a jig.

Complete Record: Series: Milling machine series Dewey number: 621.9 Audience level: sh-c-trade-adult Guide Format/cost: 16-sd-$34.66 Distributors / rental: Not shown in source

Metadata Source:Educational Film Guide 1946